.bk J02 .fl T805cJC.j .fd daily journal, feature descriptions .ed T805 .ei cJC .rd T805 .ri cJC -dy Today we continued excavating only in k5. We had hoped to reach the salmon-colored floor (f359) in this locus today but we were unable to. Work was slow as we are only using the small pick to avoid cutting through any layers. Also, we stopped several times for Adeeb to remeasure our markers. We decided to change features about 10cm down into f363 as the matrix became slightly more reddish. This was called f364. At noon the workmen went for a lecture about the site with gB so we ended work early. -sf sG is only working in the field before breakfast. After breakfast today sH went to work on site presentation with gB. -sy Adeeb came to remeasure our markers today for the correct elevations. We hope to be able to have the measurements next week. k 5 dy Today we only worked in k5. We went down only about 20 centimeters because we are working with the small pick. We have 2 pickmen working in the square. We had only 2 features and 2 q-lots. f 363 dy Today we continued removing this feature. It was composed of many flakey layers and it was difficult to follow just one layer. The layers separate easily with the trowel. tc co f364 f 364 =l f357 ds This feature is composed of plate-like layers with reddish inclusions. It is sandy and very coarse. The particles are irregularly shaped. When picked it comes off in layers. The small chunks are very friable, they break apart easily when you rub them between your fingers. nr This feature is very similar to f363 which is immediately above it, however, it is slightly more red in color so we assigned it a new feature. In k110 it would be equal to f357. f357 in k110 appeared to be one feature composed of many layers (similar to both f363 and f364) so we assigned it only one feature, however, now we are following the features in k5 across using the west section of k5 so we have a greater control for separating features so we are able to assign separate features to f363 and f364.